Tuesday, September 13, 2011

Table Transform!

I decided to change my Table into a Photo booth. so it can function for my Computer, Photo Shooting and.. maybe.... Model Building (sometimes do in the kitchen) also used the box as a Diffuser ( what an Epic Fail!. i did made one.. apparently threw it away . Here's a Sinanju Photo Shoot and Bumble Bee. 

Click the Picture to Enlarge :)










and Here's some Bumblebee Pics. the photo now looks alot better.. so now i can do a nice review with nice photos :P
Posted by at

7 comments:

  1. TsukinariSeptember 13, 2011 at 9:43 AM

    Very nice~

    ReplyDelete
  2. Khaidir SemailSeptember 13, 2011 at 9:45 AM

    Thanks :D . so now i can have a nice plain Black Background :3

    ReplyDelete
  3. B-MechaSeptember 13, 2011 at 10:05 AM

    For reflector, use aluminium foil will give u 3x better effect than the cover box.

    To get better black background. try to cover the top part of the black ppaer so the light doesn't fall on the background but only on the figure.

    ReplyDelete
  4. Khaidir SemailSeptember 13, 2011 at 10:08 AM

    good idea B... thanks for tip ^_^ kinda Started Learning PhotoGraphy last week. mostly on the Aperture and Lens haha.   the aluminum will make a Good Diffuser :D  

    ReplyDelete
  5. June Michael CadiaoSeptember 13, 2011 at 3:35 PM

    hi khaidir.. i think you are confusing "diffuser" with "reflector".. i think you used the diffuser as reflector, which is why it is a failure. to make a diffuser, cut out a rectangular hole in the box, maybe 1/2 inch away from the edges. then, cover the hole with the paper. then what you do is put the diffuser in between the figure and light source.

    like: figure - diffuser - light

    i'll probably make one tomorrow and take a pic of the set-up.

    b-mecha is right if you'll use aluminum foil as a reflector to get an even light shining on your figure.

    ReplyDelete
  6. iChi22worXSeptember 13, 2011 at 3:45 PM

    hi khaidir.. i think you are confusing "diffuser" with "reflector".. i
    think you used the diffuser as reflector, which is why it is a failure.
    to make a diffuser, cut out a rectangular hole in the box, maybe 1/2
    inch away from the edges. then, cover the hole with the paper. then what
    you do is put the diffuser in between the figure and light source.

    like: figure - diffuser - light

    i'll probably make one tomorrow and take a pic of the set-up.

    b-mecha is right if you'll use aluminum foil as a reflector to get an even light shining on your figure.

    ReplyDelete
  7. Khaidir SemailSeptember 13, 2011 at 5:57 PM

    Lol i see. thanks again. :D  will try to use an Aluminum Foil :D 
    also thanks again for the tip on the Making a diffuser ... :)

    ReplyDelete

Subscribe to: Post Comments (Atom)

Followers